GeekBox is a Hackable Android and Linux TV Box Powered by Rockchip RK3368 SoC

There are many Android TV boxes on the market based on Rockchip RK3368 processor, while I’m not aware of any development board based on the latest Rockchip octa-core processor, and Linux support is basically inexistent. One device may fill both gaps: GeekBox. This TV box can run both Android and Ubuntu Linux, while it’s easily disassembled to access expansion headers.

GeekBoxThe hardware specifications are a little higher-end than most Rockchip RK3368 TV boxes we’ve seen so far:

  • SoC – Rockchip RK3368 octa core Cortex A53 processor @ 1.2 GHz with PowerVR G6110 GPU
  • System Memory – 2GB LPDDR3@1600Mbps
  • Storage – 16GB Samsung eMMC v5.0 flash + micro SD slot
  • Video Output / Display I/F
    • HDMI 2.0 up to 4K @ 60Hz with CEC support
    • Display + touchscreen headers
  • Audio Output – HDMI
  • Connectivity – Gigabit Ethernet, 802.11 a/b/g/n + 802.11ac 2×2 MIMO @ 867 Mbps (AP6354 module), Bluetooth 4.1
  • USB – 2x USB 2.0 host ports, 1x micro USB OTG port
  • Debugging – 3-pin header for serial console
  • Security – HW security system, support popular DRM (no details though), and HDCP 1.4/2.x
  • Misc – Power, reboot and update buttons, IR receiver, fan header, RTC battery header, 2x LEDs
  • Power Supply – 5V/2A
  • Dimensions – N/A

Rorkchip_RK3368_system-on-module

Once you open the case, you’ll find GeekBox is also a Rockchip RK3368 system-on-module (SoM) with a 314-pin MXM3 edge connector. The system will be pre-installed with Android & Ubuntu Dual boot firmware, and you’ll also be able to switch to Android–based Light Biz OS. The kit will including GeekBox SoM, the enclosure, an IR Remote control, an HDMI cable, two external antennas, a charging cable, an heatsink, a power adapter and a user’s manual.If you want to do some real work, you could also get Landigship baseboard (sold separately) to insert the Rockchip RK3368 module into the MXM3 socket and get some extra features and ports including:

  • Storage – 2.5″ SATA drive support on the back of the board
  • Display – MIPI DSI header
  • Expansion Headers – 60-pin GPIO header (2.54mm pitch)
  • Camera – MIPI CSI connector
  • Audio – optical S/PDIF, 3.5mm headphone jack, two microphones
  • USB – One extra USB port
  • Misc – RTC battery slot (CR1220), 2×2 user buttons, buzzer
  • Power Supply – 5V
  • Baseboard dimensions – 116x86x13 mm
Rk3368_SoM_Landingship
GeekBox SoM and Landingship Board

The company can also provide various accessories such as a 7.9″ “retina” display,  a cooling fan, an RTC battery to connect directly to the SoM, high gain WiFi antennas (5dB), and so on.

A development platform without source code, documentation and community would rather be useless, so GeekBox.tv community has been launched for the board, where you can get support via the forums, and while firmware and source code are “comming soon”, you can already download the schematics (PDF) for GeekBox SoM and LandingShip carrier board.

GeekBox is available for pre-order for $109.99 on GeekBuying, with a $20 discount if you leave a comment on their promotion page. You also find accessories on such as the $29.90 Landingship baseboard, and others, and you could also get a complete kit for about $249. Shipping is planned for November 30.

Share this:

Support CNX Software! Donate via cryptocurrencies, become a Patron on Patreon, or purchase goods on Amazon or Aliexpress

ROCK Pi 4C Plus
Subscribe
Notify of
guest
The comment form collects your name, email and content to allow us keep track of the comments placed on the website. Please read and accept our website Terms and Privacy Policy to post a comment.
25 Comments
oldest
newest
stefan
stefan
8 years ago

Storage – 2.5″ SATA drive support on the back of the board ? Where ?

nobe
nobe
8 years ago


it seems it’s still the top picture

tkaiser
tkaiser
8 years ago

stefan :
Storage – 2.5″ SATA drive support on the back of the board ? Where ?

According to the landingship’s schematics above it’s a JMicron JM20329 USB2.0-to-SATA bridge. Don’t expect too much. They’re always slow and often lack features (SAT/UASP)

Marius Cirsta
8 years ago

Nice but way too expensive. I’ve found a 2GB RK3368 powered TV box for $66 on Ali and I’m sure I can find the UART myself, solder a bit and voila 🙂

sola
8 years ago

Is there any review about this, anywhere (I haven’t found any)?

It would be nice to know what features actually work under Ubuntu. Given the PowerVR GPU, I have a bad feeling about this (some crippled Ubuntu version with repos gone in a year and no way to upgrade it…etc)

blu
blu
8 years ago

Looks quite nice. Dare I say nicer than a 96board. No heatspreader, though? Wouldn’t 8 cores @1.2 GHz need one not to throttle?

Jay
8 years ago

At this price, once would expect at least a single USB 3.0 port

Jacob Gadikian
Jacob Gadikian
8 years ago

I’d like to pipe in here– geek box is a quantum leap in quality above anything else done in the 3368 realm, and it’s also made with hackability in mind. There are *big* plans for that humble “landing board.” Expect much, much more from this series of “as open as rockchip will allow this week” devices…. 🙂

Jacob Gadikian
Jacob Gadikian
8 years ago

@blu
The board designer, who goes by Gouwa, is himself a designer, not only an electronics engineer, hence the unique touch on… just about everything. The difference between this and that $66 dollar 3368 mentioned is that he personally seeks out the best individual components for each device he’s involved in. I’ve uploaded some photos of “his take on a 3188 tv stick” vs “average 3188 TV stick” to give you an idea.

https://drive.google.com/folderview?id=0BxLj8ItRojN-T0xNTlYwSFJSSG8&usp=sharing

Improves everything he puts his mind to, this man does…..

blu
blu
8 years ago

@Jacob
Thanks for the tip. I’ve been looking for an 8-core A53 2GB SBC (since same-count A57 don’t come cheap at all), and GeekBox looks like what I need, more so than LeMaker’s HiKey.

Marius Cirsta
8 years ago

@Jacob Gadikian
This is nice but still double the price is a lot and the RK3368 is a pretty weak SOC. Yes it’s 8 cores but they’re A53 and at 1.2 GHz so not that much …
Still it’s good that such a product exists, choice is always good. I hope kernel source will of course be available too.

blu
blu
8 years ago

..And ordered.

Man, I got so much aarch64 porting to do ; )

hex
hex
8 years ago

is it have mipi-dsi pins? ı want to use my old phone lcds on it.

unixos
unixos
8 years ago

There is a linux sdk including the toolchain for the geekbox?

At
At
8 years ago

Lacks in documentation. I got a review unit for my website and it appears they sent me a slightly defective one. Android is unusable and Linux is unstable.

Anyway, I’m used to Arduino type GPIO, where you just program the thing from the IDE and can’t find any documentation on this particular board (with the landingship) on how to use the GPIOs. Never did GPIO directly from withing linux. I’m comfortable with Linux btw, it’s my main OS for 3 years.

Do you have any info on the usage of the GPIOs pins on the landingship?

theguyuk
theguyuk
7 years ago

Not sure if real bargain but a email tells me that the Geekbox and landingship is just under £ 75.00 on promo, 24hrs left

Or just £64.00 for Geekbox, again promo, 24hrs left.

Both at Geekbuying

Khadas VIM4 SBC