ASUS PRIME J4005I-C Gemini Lake Mini-ITX Motherboard is Selling for around 80 Euros

Slowly but surely we are starting to see some Intel Gemini Lake products for sale / pre-order such as Intel June Canyon NUC Mini PC/Kits, or Jumper EBook X1 laptop, and if are based in Europe, it’s now possible to purchase ASUS PRIME J4005I-C mini-ITX motherboard for under 80 Euros.

The motherboard is equipped with an Intel Celeron J4005 dual core processor, two U-DIMM slots for up to 8GB RAM, SATA and mSATA for storage, HDMI/RGB/LVDS ports, Gigabit Ethernet, and more.

ASUS PRIME J4005I-C specifications:

  • SoC – Intel Celeron J4005 dual core processor @ 2.0 / 2.7 GHz with Intel UHD Graphics 600 up to 700 MHz; 10W TDP
  • System Memory –  2x U-DIMM sockets up to 8GB DDR4 2400/2133 MHz Non-ECC, Un-buffered Memory
  • Storage
    • 2x SATA 6Gb/s ports
    • 1x M.2 Socket with M Key, type 2260/2280 storage devices support (PCIe mode)
    • 128 Mb Flash ROM for UEFI AMI BIOS
  • Video Output
    • 1x HDMI 2.0 up to  4096 x 2304 @ 24 Hz
    • 1x D-Sub (VGA) up to 1920 x 1200 @ 60 H
    • 1x LVDS connector up to 1920 x 1200 @ 60 Hz
    • 1x Flat panel display brightness connector
    • Supports up to 3 displays simultaneously
  • Audio
    • Realtek ALC887-VD2 8-Channel High Definition Audio Codec
    • 3x Audio jacks
    • 1x S/PDIF out header
    • 1x front panel audio connector (AAFP)
    • 1x speaker connector
  • Connectivity – 1x Gigabit Ethernet via Realtek RTL8111H controller
  • USB
    • 2x USB 3.1 Gen 1 ports
    • 2x USB 2.0 ports
    • USB 2.0 internal header
  • Expansion
    • 1x M.2 Socket with E Key, type 2230 WiFi/BT devices support or PCIe/USB mode
  •  Misc
    • 1x PS/2 keyboard (purple), 1x PS/2 mouse (green)
    • 1x COM port (DB9), 1x COM header
    • 1x LPT header
    • 1x 4-pin Chassis Fan connector
    • 1x Chassis Intrusion connector(s)
    • 1x Clear CMOS jumper(s)
    • 1 x Panel off header
    • 1x System panel connector
    • ASUS 5X Protection II (LANGuard, Overvoltage Protection,DRAM Overcurrent Protection, Stainless-Steel Back I/O, ESD Guards)
  • Power Supply
    • 1x 24-pin EATX power connector
    • 1x 4-pin ATX 12V power connector
  • Dimensions – 170 x 170 mm (mini-ITX form factor).

The motherboard is said to support Windows 10 64-bit or Linux, and ships with a user’s manual, support CD/DVD with drivers,user’s manual…, an I/O Shield, two SATA cables, and an M.2 screw package. ASUS claims the motherboard follows the thin mini-ITX form factor, but the height appears higher than the 2.5cm maximum height normally used for thin Mini-ITX boards. Visit the product page for further details.

Via FanlessTech

Share this:

Support CNX Software! Donate via cryptocurrencies, become a Patron on Patreon, or purchase goods on Amazon or Aliexpress

ROCK Pi 4C Plus
Subscribe
Notify of
guest
The comment form collects your name, email and content to allow us keep track of the comments placed on the website. Please read and accept our website Terms and Privacy Policy to post a comment.
20 Comments
oldest
newest
Mark Birss
Mark Birss
6 years ago

Very nice, i want.

MiloshCZ
MiloshCZ
6 years ago

Ugly ATX power connector.

Bobby
Bobby
6 years ago

Nice, indeed, but 8GB maximum? I know RAM prices are high, but the past 10 years or so maximum RAM size has halted on most non-server equipment, often due to solder-on RAM only. Here there are RAM sockets, but still no proper RAM support. Has all the memory controller designers retired? Sigh …

fossxplorer
fossxplorer
6 years ago
willy
willy
6 years ago

Very reasonable price for the value. Too bad I don’t need it 🙂

fossxplorer
fossxplorer
6 years ago

Yeah looks good compared to many overpriced ARM boxes, although without RAM. Is there a good ATX PSU without fan?

Christian
Christian
6 years ago

Too many archaic ports instead of modern ones: PS/2, com port and header, LPT header, VGA, but no directly usable second digital display connector, no USB-C port, no USB3 headers, only 2 SATA … might be targeted as a replacement for embedded stuff that uses those archaic ports.

Mark Birss
Mark Birss
6 years ago

@fossxplorer
for these type of low power boards you can use a fanless picoPSU

like this
https://www.mini-itx.com/store/~picoPSU-90

Albert Bassa
Albert Bassa
6 years ago

For 30£. Much better and convenient to use a 12V supply, and include switching regulators in the board.

tkaiser
tkaiser
6 years ago

Christian :
no USB3 headers

The header right behind the HDMI port should carry 4 x USB3. Unfortunately I’m not aware of a lot of general purpose PCIe attached adapters that could fit into the M.2 slots (Key E and M). The only one I currently remember is for Key B: shop.t-firefly.com/goods.php?id=52

blu
blu
6 years ago

Two DIMM slots, 8GB max.. No UDIMM will be left behind with this board ; )

JotaMG
JotaMG
6 years ago

fossxplorer :
Is there a good ATX PSU without fan?

At this power level, and with this Asus boards, we usually use a cheap (sometimes used) atx PS and disconnect the fan (or cut the wires!). Also we get rid of the PS case and put the circuit inside our small custom case.

Eversor
Eversor
6 years ago

@willy These boards with integrated CPUs are not good value at all. For the same 80eur you can get a Celeron G3900 and a MATX motherboard. If you put an extra 10-15eur, you also get ITX. It has been like this ever since Braswell. The performance is on another league and you get to slam at least 16GB in there if you need. Plus, I measured an old G1840 and power consumption while stressing GPU+CPU was under 20-25W. Get these if you really need something that can run below 10W. What you save on electrical costs is not much more… Read more »

Bobby
Bobby
6 years ago


Yes, I know the memory controller is integrated. 8GB is not bad relative to higher end CPU’s, but as I see it, it is not enough in either end.

willy
willy
6 years ago

Eversor : @willy For the same 80eur you can get a Celeron G3900 and a MATX motherboard From ark, the Celeron G3900’s TDP is 51W, which in no way will fit such a low-profile fanless design. Also at around 35 EUR for the CPU that doesn’t leave much room for the mainboard and the heatsink. BTW, my current SSD-based NFS server runs perfectly fine with its 2 GB of RAM so I really don’t need to go up to 16G, and this one being limited to 8G is not a problem at all for such a use case. I’d say… Read more »

tkaiser
tkaiser
6 years ago

willy :
I’d say this board only misses 2 SATA ports to be able to replace my server (which could be added using an add-on SATA controller)

How? Do you know a single such PCIe attached SATA controller with M.2 key M or E? Or using the SuperSpeed USB ports since ‘fast enough’?

Eversor
Eversor
6 years ago

@willy You can find multiple MATX motherboards + G3900 w/ heatsink (the included one, which is low-ish profile and low noise) for *under 80eur*. For 95eur you can get a combo with ITX motherboard – on a part that is much higher performance. These only make sense for very small NAS and I don’t find these worth more than 50eur unless you fit in the top quad core model. Those TDP numbers are meaningless. Ever since Ivy Bridge, Intel has been pushing very high TDP numbers for non-K CPUs. G1840 is sub-25W at 2.8GHz and a G3900 is certainly below… Read more »

willy
willy
6 years ago

tkaiser :

Do you know a single such PCIe attached SATA controller with M.2 key M or E?

Indeed, not as a single board apparently. I can find a number of passive M2-M to single-SATA connector, as well as M2-M to PCIe-x4 to which you can then connect your own SATA board. Or there’s the small version of it, by turning your M2 to mPCIe, then plug an mPCIe dual-SATA board :
http://www.bplus.com.tw/ExtenderBoard/P15S-P15F.html
http://www.bplus.com.tw/Adapter/PM1061R.html

But I don’t like having to chain multiple adapters like this, reliability is never fantastic over the long term…

tkaiser
tkaiser
6 years ago

willy : I can find a number of passive M2-M to single-SATA connector, as well as M2-M to PCIe-x4 Both not really an option since while M.2 key M could carry SATA it does not in this case (the Celeron J4005 has only two native SATA ports which are already used). M.2 key M also could expose 4 PCIe lanes but again since the el cheapo Celeron is running out of PCIe lanes only two are available here: 1 x M.2 Socket 1 with E Key, type 2230 WiFi/BT devices support or PCIe/USB mode 1 x M.2 Socket 3 with… Read more »

Khadas VIM4 SBC