GL.iNet Brume-W (GL-MV1000W) is a “pocket-sized wireless gateway for edge computing” that supports high-speed VPN up to 280Mbps with WireGuard, AdGuard ad-blocking software (AdGuard), and Tor.
The device features three Gigabit Ethernet ports and built-in 2.4 GHz WiFi 4 connectivity, but it also supports Alfa AWUS036AC and AWUS036ACS USB WiFf USB dongles for users wanting dual-band WiFi 5 (AC) networking. The router ships with OpenWrt pre-installed, but also supports Ubuntu.
- SoC – Marvell ARMADA 88F3720 (aka ARMADA 3720) dual-core Cortex-A53 processor @ 1.0 GHz with packet processor/network accelerator
- System Memory – 1GB DDR4
- Storage – 16MB NOR flash and 8GB eMMC flash, MicroSD card slot up to 256GB
- 3x Gigabit Ethernet ports (1x WAN + 2x LAN)
- Built-in 2.4 GHz 802.11b/g/n WiFi 4 up to 300 Mbps with external WiFi antennas
- Support for external 802.11ac WiFI 5 USB dongles
- USB – 1x USB host port, 1x USB-C port
- Misc – Power, WiFi, VPN status LEDs; power button; mode button to switch VPN/Tor on or off
- Power Supply – 5V/3A via USB-C port
- Dimensions – 88 x 68 x 24mm
- Weight – 115 grams
- Temperature Range – 0 to 40°C
The design is very similar to the company’s Slate router but with a different processor, much more storage and memory allowing to perform better, and run Ubuntu for people wanting more advanced features.
Most people are likely to keep using OpenWrt since it comes with an easy-to-use admin panel available from a web browser or the GL.iNet mobile app for Android or iOS. You’ll find more details to get started and configure the wireless gateway on the Wiki that’s both for the earlier Brume (without WiFi) and the new Brume-W covered in this article.
There’s very little information about the Ubuntu image, but I’d assume you’d be on your own for configuration and setup. Marvell ARMADA 3720 is found in several hardware platforms running Ubuntu including Marvell ESPRESSOBin board and Blueendless X3 Networked HDD NAS case, and upstreaming to mainline Linux looks good too, so I’d be quite confident about Ubuntu support on this hardware.
GL.iNet launched Brume-W router on Kickstarter with a $50,000 HKD ($6,450 US) funding target that’s already been surpassed. Rewards start at around $120 US for the router with 5V/3A power supply, Ethernet cable and user manual. Shipping further adds around $25, and backers should expect their package to be shipped in September 2020.
Jean-Luc started CNX Software in 2010 as a part-time endeavor, before quitting his job as a software engineering manager, and starting to write daily news, and reviews full time later in 2011.
|Support CNX Software - Donate via PayPal, become a Patron on Patreon, or buy review samples|