development board

Posted on by Jean-Luc Aufranc (CNXSoft) - 44 Comments on Status of Orange Pi Boards GPIO Support

Status of Orange Pi Boards GPIO Support

Yesterday, one person asked me to make a video showing GPIO control on Orange Pi 2 mini on YouTube, and since I have just completed a post about Orange Pi camera, I thought it might be fun to check GPIO support too. This post focuses on Allwinner H3 boards, but the instructions and status should be very similar for Allwinner A20 and A31s versions. One of the first things you want before starting playing with GPIOs is the expansion header’s pinout chart, and I could not find any until I had the idea to check for schematics, which are available on Orange Pi resources page. I downloaded the schematics for Orange Pi 2, which should be the same as for Orange Pi 2 mini as the only difference is the lack of WiFi module. Orange Pi PC is a little different, and the schematics are nowhere to be found, but […]

Posted on by Jean-Luc Aufranc (CNXSoft) - 40 Comments on How to Use Orange Pi Camera in Linux (with Motion)

How to Use Orange Pi Camera in Linux (with Motion)

Earlier this month, I wrote a Quick Start Guide for Orange Pi Allwinner H3 boards such as Orange Pi PC, and showed how to install and configure Debian on the boards. I’ve also received the $5.90 Orange Pi camera, which when combined an Orange Pi PC, costs around $27 including shipping. So today, I’ve attached the CSI camera to my Orange Pi 2 mini board, and used it with motion to transform for the board into an IP camera. First, you’ll need to insert the camera into CON1 connector with the camera facing the ceiling, and close the black clip to keep it in place. Now connect all cable and power on your board. First, I studied the steps described on that forum thread, and modified Allwinner configuration files, but after one or two hours, I found out some work at been done since May, and it was now much […]

Posted on by Jean-Luc Aufranc (CNXSoft) - 9 Comments on LeMaker Hikey 96Boards Development Board Comes with 1 to 2GB RAM, Sells for $75 and Up

LeMaker Hikey 96Boards Development Board Comes with 1 to 2GB RAM, Sells for $75 and Up

Hikey was the first 64-bit ARM development board compliant with 96Boards specifications, and supported by Linaro. Availability always seemed to be an issue however, and pricing was set to $129. But Lemaker, the makers of Banana Pi boards, recently joined Linaro, and they’ve built a lower cost version of the Hikey board, still featuring Hisilicon Kirin 620 octa-core ARM Cortex-A53 processor, but with 1GB and 2GB RAM versions, priced respectively at $75 and $99. LeMaker Hikey board specifications: SoC – HiSilicon Kirin 620 octa core Cortex A53 processor @ 1.2 GHz with ARM Mali-450MP4 GPU System Memory – 1 or 2 GB LPDDR3 @ 800 MHz Storage – 8GB eMMC + micro SD slot Video Output / Display – HDMI up to 1080p, MIPI-DSI interface Connectivity – 802.11 a/b/g/n Wi-Fi, Bluetooth 4.1 LE (WL1835MOD module) USB – 2x USB 2.0 host ports, 1x micro USB OTG Camera – MIPI CSI […]

Posted on by Jean-Luc Aufranc (CNXSoft) - No Comments on Ingenic X1000 MIPS Processor and X1000 Phoenix Board Target IoT and Embedded Applications

Ingenic X1000 MIPS Processor and X1000 Phoenix Board Target IoT and Embedded Applications

Ingenic is a Chinese SoC vendor that makes processors featuring their X-Burst cores based on MIPS architecture. Their JZ47 series can be found in tablets and development boards such a MIPS Creator CI20, while their M series, including Ingenic M200, are dedicated to wearables & IoT applications. The company has now launched X series starting with X1000 processor which include an audio codec, a Voice Trigger Engine (VTE) and 32MB RAM in package. Ingenic X1000 features: CPU Core – Ingenic MIPS XBurst 32-bit core up to 1.0 GHz, Double precision hardware float point unit, L1 cache 16KB/16KB, and L2 cache 128KB Security Core – On-chip security ROM and RAM, hardware AES and RSA, supports security boot and user customization Memory 32MB LPDDR in package Support 16-bit DDR2, DDR3 and LPDDR up to 512MB Support Quad-SPI NOR/NAND, eMMC, SDHC Display –  8-bit, 9-bit, 16-bit parallel interface SLCD up to 640×480@60Hz, 24 […]

Posted on by Jean-Luc Aufranc (CNXSoft) - 3 Comments on HummingBoard Gate Boards Add a mikroBUS Socket to Support MikroElektronika Click Boards

HummingBoard Gate Boards Add a mikroBUS Socket to Support MikroElektronika Click Boards

SolidRun already released HummingBoard-Base, HummingBoard-Pro, and HummingBoard Edge previously, but the company has now launched another version of their Freescale i.MX6 based boards with HummingBoard Gate that adds a mikroBUS socket to support over 150 add-on boards – called Click Boards – made by MikroElektronika. HummingBoard Gate specifications: SoC – Freescale i.MX6 Solo, Dual Lite, Dual, or Quad with Cortex-A9 cores @ 1 to 1.2 GHz System Memory – Up to 4GB DDR3 Storage – Micro SD slot Connectivity – Gigabit Ethernet (limited to 470Mbps), optional WiFi/Bt module Video Output – HDMI output, MIPI-DSI connector Camera – MIPI CSI-4, parallel camera USB – 4x USB 2.0 ports Expansion mPCIe slot with SIM card holder 36-pin GPIO header mikroBUS click interface Misc – Reset button, RTC with battery Power – 7-36V, 5.5mm jack Dimensions – 102 x 69 mm As usual, the board is comprised of a baseboard and a microSOM, […]

Posted on by Jean-Luc Aufranc (CNXSoft) - 1 Comment on Atmel Introduces SAMA5D2 Cortex A5 SoC with Extended Temperature Range, Lower Power Consumption

Atmel Introduces SAMA5D2 Cortex A5 SoC with Extended Temperature Range, Lower Power Consumption

Today, the news broke out that Atmel will be bought by Dialog Semiconductor for about $4.6 billion. The Anglo-German company is little known as their main products are PMIC, audio and connectivity chips, but they’ve still managed to get the financing to purchase Atmel. But that’s not the purpose of the post today, and instead I’ll cover a new SAMA5 Cortex A5 SoC recently announced by the company, targeting industrial Internet of Things, wearables and point of sale applications. SAMA5D2 key features and benefits: ARM Cortex-A5 core running at 500MHz (785DMIPS). Floating point unit (FPU) for high-precision computing and accelerated data processing. 128KB of L2 cache for system performance Low power consumption Less than 150mW in active mode at 500MHz with all peripherals activated Less than 0.5mW in low power mode with SRAM and registers retention Sub 200µA in retention mode with context preserved New backup mode with DDR in […]

Posted on by Jean-Luc Aufranc (CNXSoft) - 9 Comments on Allo SPARKY Board Supports Raspberry Pi HATs for Multimedia, IoT and VoIP Applications

Allo SPARKY Board Supports Raspberry Pi HATs for Multimedia, IoT and VoIP Applications

Allo is a company based in Bangalore, India specializing in VoIP hardware solutions, but they’ve recently developed a single board board powered by Actions Semi S500 quad core processor that supports various Raspberry Pi HATs and can be used for multimedia, IoT, and Telecom application such as Asterix or Freeswitch PBX. Allo SPARKY board specifications: SoC – Actions Semi S500 quad core Cortex A9r4 processor with PowerVR SGX544 GPU @ 500 MHz Memory – 1 or 2GB RAM Storage – Socket for 8, 16, 32 or 64GB pluggable eMMC modules,  micro SD slot up to 32GB, optional NAND flash Video Output – HDMI,  34-pin LCD connector Audio – HDMI, Headphone jack, built-in microphone Video Codec – H.265 (HEVC) and Ultra HD (4K*2K) video playback. Encoding up to 1080p@60fps. Connectivity – 10/100M Ethernet USB – 2x USB 2.0 host ports, 1x USB 3.0 (OTG) port Camera –  24-pin camera interface (Up […]

Posted on by Jean-Luc Aufranc (CNXSoft) - 15 Comments on Inforce 6410Plus Single Board Computer with Snapdragon 600 SoC Sells for $98 (Promo)

Inforce 6410Plus Single Board Computer with Snapdragon 600 SoC Sells for $98 (Promo)

Inforce 6410Plus SBC is the successor of Inforce 6410 board, also based on Qualcomm Snapdragon 600 processor (APQ8064), but compared to the first version of the board, it adds GPS/Glonass, some MIPI CSI and DSI interface,and a few others changes. The normal price is $143, but it is currently selling for $98 for a limited period. I’ve reproduced the specifications below as a reminder: SoC – Qualcomm Snapdragon 600 (APQ8064) Quad Core Krait 300 processor  @ 1.7GHz + Adreno 320 GPU System Memory – 2GB on-board PCDDR3, up to 533MHz Storage – 4GB eMMC + μSD card connector + SATA interface Connectivity: 802.11 b/g/n WiFi (Atheros QCA6234) Bluetooth 4.0 (Atheros QCA6234) 10/100/1000bps Ethernet (Atheros 8151) GPS/GLONASS Video and Audio Interfaces: μHDMI (1080p) 2x MIPI-CSI2 (4-lane, up to 20MP camera @ 15 fps) Dual MIPI-DSI (4 lane) – Primary : up to QWXGA (2048 × 1536), 60 Hz refresh rate; Secondary:  […]