canonical News - Page 5 of 5 - CNX Software

David Mandala of Canonical talked at Linux.Conf.Au on 18th of January 2012 about Ubuntu for ARM and the move from netbook to server support. You can read my notes below, or jump at the end of this post to watch the presentation. The Past 2008: Ubuntu decides to only support ARMv7 architecture vs. Debian that supports ARMv4 and above. 2009: Ubuntu release for Freescale i.MX51 (ARMv5 built), and then Marvell ARMAVA with ARMv6 and VFP (ARM floating point unit) support. 2010: April (10.04) The first ARMv7 release for OMAP3 (Beagleboard) with VFP, Thunb2, NEON and SMP for ARM and first netbook edition October (10.10) Pandabord (OMAP4) release with initial device tree support for ARM. Starts work with Linaro. 2011: 11.04 (5th release) – Supports OMAP3 and OMAP4 only. The netbook edition is using Qt, further improvement to device tree, further work with linaro and on the way to the Unified […]

Canonical showcases several demos at ARM Techcon 2011: Toshiba AC-100 Netbook (Nvidia Tegra 2) running Ubuntu 11.10. with Unity interface. Freescale i.MX53 board playing a 1080p video in Ubuntu 11.10. TI Pandaboard running Ubuntu 11.10 Server Edition. Ubuntu 11.04 is not officially supported for Toshiba AC-100, but the community if working on it and the image can be downloaded at http://ac100.gudinna.com/ Canonical however supports Netbook and Headless (Server) edition for OMAP3 (Beagleboard) and OMAP4 (Pandaboard). Those image are available at https://wiki.ubuntu.com/ARM/NattyReleaseNotes Watch the interview by Charbax and demos in the video below. Jean-Luc Aufranc (CNXSoft)Jean-Luc started CNX Software in 2010 as a part-time endeavor, before quitting his job as a software engineering manager, and starting to write daily news, and reviews full time later in 2011. www.cnx-software.com

canonical

The Past, Present and Future of Ubuntu for ARM

Ubuntu on Tegra 2 Netbook and Ubuntu Server on Pandaboard