Day: August 6, 2020

Posted on by Jean-Luc Aufranc (CNXSoft) - No Comments on iWave Telematics Control Unit Supports GPS, 4G LTE, WiFi, and Bluetooth

iWave Telematics Control Unit Supports GPS, 4G LTE, WiFi, and Bluetooth

iWave Telematic Control Unit

We’ve often written about iWave Systems’ single board computers, development kits, and systems-on-module, but the company has also been offering automotive products such as a Linux based OBD-II Dongle. And they’ve just introduced a new one called Telematics Control Unit (TCU) based on an Arm Cortex-A7 processor and offering GPS, 4G LTE Cat 4/1/M1, WiFi 5, and Bluetooth 5.0 connectivity for vehicle fleet management and insurance companies that want to know how drivers behave… iWave Telematics Control Unit (TCU iW-G26) specifications: Processor – Arm Cortex-A7 based CPU @ 792MHz (likely NXP i.MX 7ULP) System Memory – 256MB DDR3L SDRAM Storage – 4GB eMMC Flash Connectivity 4G LTE Cat 4, Cat 1, Cat M1 (eMTC) 802.11b/g/n Wi-Fi 4 or 802.11b/g/n/ac Wi-Fi 5 (Hotspot & Station mode) Bluetooth 5.0 GNSS – GPS/A-GPS receiver with antenna Sensors – 3-axis accelerometer, 3-axis gyroscope, 3-axis magnetometer OBD Features & Protocols 12V Power Input from TCU […]

Posted on by Jean-Luc Aufranc (CNXSoft) - 3 Comments on RAK2287 Mini PCIe LoRaWAN Concentrator Module Supports up to 500 Nodes per km2

RAK2287 Mini PCIe LoRaWAN Concentrator Module Supports up to 500 Nodes per km2

RAK2287 LPWAN Concentrator Module

RAK Wireless launched its first Mini PCIe LoRaWAN concentrator module in 2018 with RAK833 mPCIe card featuring Semtech SX1301 LoRa baseband chip. It was soon followed by RAK2247 mPCIe with a very similar design but some tweaks to increase its maximum transmission power and range, and improve thermals and stability with the addition of a heatsink. The company has now introduced a new version with RAK2287 Mini PCie LoRaWAN concentrator module being mostly inspired by RAK2247 module but replacing Semtech SX1301 by Semtech SX1302 LoRa transceiver that’s suppose to reduce current consumption (and heat), lower the BoM cost, and able to handle a higher amount of traffic. The new mini PCIe card also adds u-blox ZOE-M8Q GPS system-in-package to provide GNSS functionality. RAK2287 key features and specifications: LoRa Connectivity Semtech SX1302 LoRa Transceiver with 2x SX1250 Tx/Rx front-end Tx power – up to 27dBm Rx sensitivity – down to -139dBm […]

Posted on by Jean-Luc Aufranc (CNXSoft) - 1 Comment on MEGA-RTD Raspberry Pi HAT Offers up to 64 Resistance Temperature Detectors (Crowdfunding)

MEGA-RTD Raspberry Pi HAT Offers up to 64 Resistance Temperature Detectors (Crowdfunding)

MEGA-RTD Raspberry Pi HAT

Sequent Microsystems like to make stackable Raspberry Pi HATs. After their stackable 4-relay board allowing for up to 32 relays controlled by a Raspberry Pi board, the company has now launched MEGA-RTD 8-channel RTD Raspberry Pi HAT enabling up to 64 resistance temperature detectors via 8x MEGA RTD board stacked on top of a Raspberry Pi board. If you haven’t heard about this type of temperature sensors, we wrote a post explaining the advantages and drawbacks of resistance temperature detectors last year. Basically, those temperature sensors contain a resistor that changes resistance value as their temperature changes, and support much wider temperature ranges than traditional temperature sensors such as DHT22 while keeping a <0.1°C accuracy. The price of the sensors themselves is similar to traditional sensors, but the total price is more expensive since they require extra hardware to measure the resistance/voltage value. MEGA-RTD key features and specifications: MCU – […]