development board News - Page 102 of 291 - CNX Software

May 13, 2020May 13, 2020 by Jean-Luc Aufranc (CNXSoft) - No Comments

BeagleBone Green Gateway SBC with Ethernet, WiFi, and Bluetooth Launched for $60

BeagleBone Green Gateway SBC was first unveiled last July as an update to BeagleBone Green Wireless board with Ethernet, and Octavo Systems OSD3358 SiP along with some smaller changes like support for 12V power supply and I2C RTC + battery. The board did however lose two USB 2.0 ports to make space for the Ethernet connector. The board was not quite available at the time, but the good news is that you can now buy BeagleBone Green Gateway for $59.99 on Seeed Studio. Specifications have remained the same as the ones provided for the initial announcement: SiP – Octavo Systems OSD3358 with Texas Instruments AM3358 Arm Cortex-A8 processor @ 1.0 GHz, 2×32-bit 200-MHz programmable real-time units (PRUs), 3D graphics accelerator, 512MB DDR3 SDRAM, 4KB EEPROM, and integrated power management Storage – 4GB 8-bit eMMC on-board flash storage (Kington) + microSD socket Connectivity 10/100Mbps Ethernet (RJ45) WiFi 802.11 b/g/n 2.4GHz + […]

May 12, 2020October 15, 2020 by Jean-Luc Aufranc (CNXSoft) - 14 Comments

Teensy 4.1 Board Gets Longer for Ethernet, MicroSD Slot, and More GPIOs

What comes after Teensy 4.0? Teensy 4.1. The new version of the Arduino compatible board is powered by the same NXP i.MX RT1062 Cortex-M7 crossover processor clocked at 600 MHz, but about doubling in length in order to add a 10/100 Mbit Ethernet PHY, a MicroSD card slot, and offer more I/Os. Teensy 4.1 also increases flash memory to 8 MB (vs 2 MB for Teensy 4.0), and the USB hot-plugging power management circuitry needed to plug a USB device via a USB host cable. Teensy 4.1 specifications: SoC – NXP i.MX RT1062 Arm Cortex-M7 processor at 600 MHz with 1024KB RAM (512KB is tightly coupled), Storage – 8 MB serial flash (64KB reserved for recovery & EEPROM emulation), MicroSD Socket, footprints for 2x extra QSPI chips such as flash or 8MB PSRAM chip USB – 1x micro USB port for power and programming Networking – 6-pin Ethernet header via […]

May 11, 2020 by Jean-Luc Aufranc (CNXSoft) - No Comments

4K Vision Edge Computing Platform Features Xilinx Zynq UltraScale+ ZU3EG MPSoC

Last year, MyIR Tech introduced MYD-CZU3EG development board powered by a Xilinx Zynq UltraScale+ ZU3EG MPSoC with Arm Cortex-A53 cores and FPGA fabric designed for applications such as cloud computing, machine vision, flight navigation, and other complex embedded applications. The company has now announced another Zynq Ultrascale+ ZU3EG based platform dedicated to machine vision. The VECP Starter Kit (Vision Edge Computing Platform) is comprised of MYD-CZU3EG-ISP development board fitted with the company’s MYC-CZU3EG Zynq UltraScale+ MPSoC CPU module, a fansink, and a SONY IMX334 4K camera sensor. MYD-CZU3EG-ISP development board specification: MYC-CZU3EG SoM MPSoC – Xilinx Zynq UltraScale+ XCZU3EG-1SFVC784E (ZU3EG, 784 Pin Package) MPSoC with quad-core Arm Cortex-A53 processor @ 1.2 GHz, dual-core Cortex-R5 processor @ 600 MHz, Arm Mali-400MP2 GPU, and 16nm FinFET+ FPGA fabric (154K logic cells, 7.6 Mb memory, 728 DSP slices) System Memory – 4GB DDR4 @ 2,400MHz Storage – 4GB eMMC Flash, 128MB QSPI Flash […]

May 8, 2020January 28, 2021 by Jean-Luc Aufranc (CNXSoft) - 8 Comments

Skytraq PX1122R Tiny Multi-Band RTK GNSS Module Offers Centimeter Accuracy

Skytraq PX1122R Multi-Band RTK GNSS Module

Several years ago Skytraq introduced NavSpark mini, a tiny (17x17mm) GPS module, that sold for $6. I got one and wrote a post explaining how to get started with the GPS module using GNSS viewer program. The company contacted me again today, as they’ve now launched an even smaller module Skytraq PX1122R measuring just 16x12mm, supporting GPS, Galileo, GLONASS, and Beidou signals, as well as Real-time Kinematic (RTK) relative positioning technique that allows for 1-3cm positioning accuracy. Skytraq PX1122R RTK GNSS module key features & specifications: Chipset – SkyTraq PX100 Phoenix GNSS chipset Supported GNSS standards & bands – GPS L1/L2C, Galileo E1/E5b, Beidou B1I/B2I, GLONASS L1/L2, QZSS L1/L2C Integrated RTK with 1cm + 1ppm RTK accuracy in seconds (under 10 seconds) Up to 10Hz quad-GNSS RTK update rate Base or rover mode configurable Serial Interface – 3V LVTTL level 24x castellated holes with UART, RF input, 1PPS, Reset, 3.3V, […]

May 6, 2020 by Jean-Luc Aufranc (CNXSoft) - 2 Comments

OKdo E1 Arm Development Board Launched with NXP LPC55S69 Cortex-M33 MCU

We’ve just written about the launch of NXP LPC551x/S1x Arm Cortex-M33 MCU family, but OKdo has very recently announced a development board based on the previous generation LPC5500 Cortex-M33 processor, namely OKdo E1 powered by an NXP LPC55S59 dual-core Cortex-M33 processor. OKdo E1 specification: MCU – NXP LPC55S69JBD100 dual-core Arm Cortex-M33 @ up to 150 MHz with 640KB flash, 320 KB SRAM, FPU, Arm TrustZone, CASPER Crypto co-processor, and PowerQuad Hardware Accelerator for fixed and floating-point DSP functions Expansion – 32x through holes and castellated holes with Up to 9x Flexcomm interfaces (SW selectable as USART, SPI, I2C, or I2S interface) GPIOs, I2C, ADC, UART, SPI, etc… USB – 1x Micro USB 2.0 “User” port, 1x Micro USB 2.0 port for debug and power Debugging In-built CMSIS-DAP v1.0.7 debugger based on LPC11U35 Micro USB port with UART over USB virtual COM port Clocks – Internal PLL support up to 100MHz […]

May 4, 2020June 6, 2020 by Jean-Luc Aufranc (CNXSoft) - 5 Comments

NXP LPC551x/S1x Arm Cortex-M33 MCU Family Launched with LPC55S16 Development Board

NXP has announced the general availability of LPC551x/S1x Arm Cortex-M33 MCU family with low power consumption, embedded security, pin-, software- and peripheral-compatibility. The LPC551x/S1x family is manufactured using a cost-effective 40-nm NVM process technology and targets industrial and general embedded markets. An LPC55S16 based development board – PLC55S16-EVK – is also offered for evaluation and software development. NXP LPC551x/S1x MCU Key features and specifications: CPU – Arm Cortex-M33 core @ up to 150 MHz delivering over 600 EEMBC CoreMarks and consuming as low as 32uA/MHz Memory and Storage – Up to 256 KB on-chip flash; up to 96 KB SRAM; 128 KB boot ROM Peripherals CAN FD / CAN 2.0 Dual-USB with on-chip PHY, supporting both HS and FS modes SDIO and up to 9 FlexComm interfaces (configurable as either SPI/I2C/I2S, UART) Up to 64x GPIO pins 16-bit ADC with five differential channel pair Comparator with five input pins and […]

April 28, 2020April 29, 2020 by Jean-Luc Aufranc (CNXSoft) - 25 Comments

Allwinner V831 AI Full HD Camera SoC Powers Sochip V831 Development Board

In the last year or so, we’ve started to see several camera SoCs with a built-in NPU or SIMD instructions to accelerate face detection, objects detection and so on, starting with the low-resolution Kendryte K210 processor to the 2.5K Ingenic T31 MIPS video processor, or even the 4K capable iCatch V37 camera SoC. Allwinner introduces several camera processors (V3, V316, S3…) in the past, but none of them included an NPU aka AI accelerator. This has now changed with Allwinner V831 Cortex-A7 Full HD camera SoC also including a small 200 GOPS NPU. Sochip / Allwinner V831 AI Camera SoC Specifications: CPU – Single-core Arm Cortex-A7 processor @ up to 800 MHz with NEON, 32KB L1 instruction cache and 32KB L1 Data cache, 128KB L2 cache AI Accelerator – 0.2 TOPS (200 GOPS) NPU for face recognition, face detection, and “humanoid detection network” System Memory – 64MB on-chip DDR2 RAM […]

April 27, 2020 by Jean-Luc Aufranc (CNXSoft) - 2 Comments

ESP32-Korvo AI Development Board Leverages ESP-Skainet Voice Assistant

Last September, Espressif Systems unveiled ESP-Skainet voice assistant optimized for ESP8266 and ESP32 wireless SoC with support for WakeNet wake word engine and MultiNet speech commands recognition with the former requiring just 20KB RAM for one word, and the latter supporting up to 100 offline commands as long as you had 4MP SPI flash or more. At the time, it only supported the Chinese language and worked on the upcoming “LyraT-Mini audio board“, now available for $26.99 shipped but only including one microphone. Espressif Systems has now announced a better AI development board with ESP32-Korvo AI development board includes featuring a mainboard with ESP32 processor and an audio ADC, and a subboard equipped with a 3-mic array, RGB LEDs, and various buttons. ESP32-Korvo specifications: Mainboard Wireless module – ESP32-WROVER-B with ESP32 dual-core Wi-Fi / BT processor, 128 Mbit SPI flash, and 64 Mbit PSRAM Storage – MicroSD card slot Audio […]