Arduino UNO R3 Clones Now Cost Less than $5

An original Arduino UNO R3 costs about nearly $25, and I remember clones would cost about $10 on Aliexpress, but today I’ve been informed about VISduino, an Arduino UNO R3 clone, with some cost optimizations such as cheaper components and connectors, which sells for just 15.50 CNY (~$2.50 US) on Taobao, and $4.90 on Electrodragon. But double checking on Aliexpress, I could find another popular Arduino UNO R3 clone for $4.58 including shipping, but no USB cable.

VISduino
VISduino Arduino Board Clone

Both boards cut costs by replacing ATmega16U2 by CH340 USB to serial chip, and replacing the ATMEGA328P-PU MCU (DIP) by an SMT version of the Atmel MCU such as ATMEGA328P-AU (QFP).

Other changes on VISduino include:

  • Replaced USB B-type connector by a micro USB port
  • Added extra through holes side-by-side with the Arduino headers for easier debugging.
  • Extra 2×4 pin holes with TX, RX, VCC, GND, and I2C pins

You may have to install extra drivers for CH340.

Thanks to Benjamin (Zoobab) for the tip.

Share this:
FacebookTwitterHacker NewsSlashdotRedditLinkedInPinterestFlipboardMeWeLineEmailShare

Support CNX Software! Donate via cryptocurrencies, become a Patron on Patreon, or purchase goods on Amazon or Aliexpress

ROCK Pi 4C Plus

8 Replies to “Arduino UNO R3 Clones Now Cost Less than $5”

Leave a Reply

Your email address will not be published. Required fields are marked *

Khadas VIM4 SBC
Khadas VIM4 SBC