devkit News - Page 9 of 60 - CNX Software

January 10, 2023January 10, 2023 by Jean-Luc Aufranc (CNXSoft) - No Comments

MistySoM Renesas RZ/G2L or RZ/V2L SoM and devkit goes for $112 and up

MistySOM devkit Renesas RZ/G2L or RZ/V2L

We’ve previously written about several system-on-modules and SBCs based on Renesas RZ/G2L or RZ/V2L Cortex-A55/M33 processors such as Geniatech “AHAURA” RS-G2L100 and “AKITIO” RS-V2L100 single board computers, Forlinx FET-G2LD-C system-on-module, and SolidRun RZ/G2LC SOM and devkit. But most of those are hard to buy, and you need to contact the company, discuss your project, etc… before purchase, except for the SolidRun Renesas RZ/G2LC Evaluation Kit going for $249. Another option is the MistyWest MistySOM module offered for $112 and up on GroupGets with either Renesas RZ/G2L or RZ/V2L processor, as well as an optional carrier board. MistySOM system-on-module MistySOM-G2L (aka MW-G2L) and MistySOM-V2L (aka MW-V2L) specifications: SoC – Renesas RZ/G2L or RZ/V2L with dual-core Cortex-A55 processor @ 1.2 GHz, Arm Cortex-M33 core @ up to 200 MHz, Arm Mali-G31 GPU, and DRP-AI vision accelerator (RZ/V2L only) System Memory – 2GB LPDDR4/DDR4 Storage – 32GB eMMC flash 2x 120-pin high-speed mezzanine […]

January 9, 2023January 10, 2023 by Jean-Luc Aufranc (CNXSoft) - 3 Comments

Panthronics PTX30W is a 1W NFC wireless charging listener IC

Panthronics PTX30W is an NFC wireless charging listener chip that can receive up to 1W as per the NFC Wireless Charging (WLC) specification unveiled in 2020 and integrates a power management unit and a Li-Ion battery charger. Offered in a compact 3.2mm2 (1.78 x 1.78 mm) WL-CSP package, the PTX30W will enable small battery-powered products, such as smartwatches and other wearables, to be charged over NFC. The chip can operate in standalone mode or connected to a host microcontroller, and the company claims it is around four times smaller than existing designs based on multiple discrete components. PTX30W features and specifications: Integrated NFC Wireless Charging Listener device Efficient Active Rectifier RF interface according to Forum Type 2 Tag Li-Ion battery charger with charging current from 5mA to 250mA MCU LDO with 1.8V or 3.3V output, up to 50mA Embedded power negotiation logic High-efficiency NFC wireless charging listener IC with up […]

January 7, 2023January 7, 2023 by Jean-Luc Aufranc (CNXSoft) - 4 Comments

Sub-$5 Cavli C16QS CAT1.bis cellular IoT module features Qualcomm QCX216 modem

Qualcomm QCX216 LTE IoT modem was announced at the end of last year as one of the first solutions supporting the new CAT1.bis standard enabling smaller, simpler, and cheaper modules with a single antenna design. This chip also integrates a WiFi scanner exclusively used for indoor positioning. Cavli Wireless C16QS CAT1.bis is one of the first cellular IoT modules based on the Qualcomm QCX216, and we now have a clearer idea of what “cheaper” means since the company says it will sell those for less than $5 to OEMs, although that price is likely in very high quantities, possibly 100k+ or one million pieces. Cavli C16QS specifications: Wireless IC – Qualcomm QCX216 with dual-core Cortex-M3 @ 204 MHz, cellular modem-RF Storage – 4 MB Cellular connectivity LTE CAT 1.bis based on 3GPP Release 14 Peak speeds – 10Mbps (DL), 5Mbps (UL) Bands EMEA: B1/B3/B5/B8/B20 North America : B2/B4/B12/B13/B66/B71 Integrated eSIM […]

January 5, 2023January 5, 2023 by Jean-Luc Aufranc (CNXSoft) - 5 Comments

Banana Pi BPI-CM4 Amlogic A311D system-on-module launched for $95

Banana Pi BPI-CM4 on Raspberry Pi CM4 IO board

Banana Pi BPI-CM4 system-on-module powered by an Amlogic A311D hexa-core Cortex-A73/A53 processor and compatible with the Raspberry Pi CM4 module has now been launched for $95 and up. Banana Pi introduced the Raspberry Pi CM4 compatible module with Amlogic A311D CPU last May with some 3D renders and specifications, and we expected a launch in Q4 2022 or Q1 2023 at the time. The Banana Pi BPI-CM4 is now available together with a carrier board so let’s have another look. Banana Pi BPI-CM4 specifications: SoC – Amlogic A311D hexa-core processor with 4x Arm Cortex-A73 @ 2.0 GHz and 2x Arm Cortex-A53, Arm Mali-G52 MP4 (6EE) GPU, 5 TOPS NPU System Memory – 4GB LPDDR4 RAM Storage – 16GB eMMC flash (up to 128GB) Networking Realtek RTL8211F Gigabit Ethernet PHY on-module Dual-band WiFi 5 up to 867Mbps and Bluetooth 5.2 via Realtek RTL8822CS module and 2x u.FL antenna connectors 2x 100-pin […]

January 4, 2023 by Jean-Luc Aufranc (CNXSoft) - 7 Comments

Forlinx FET-MX9352-C – An NXP i.MX 9352 system-on-module for industrial AIoT applications

Forlinx FET-MX9352-C is a system-on-module based on NXP i.MX 9352 dual Cortex-A55 processor with Cortex-M33 real-time core and a 0.5 TOPS AI accelerator that can be used for industrial control, IoT gateways, medical equipment, and various applications requiring machine learning acceleration. The FET-MX9352-C follows last week’s announcement of the iWave Systems iW-RainboW-G50M OSM module and SBC with a choice of NXP i.MX 93 processors. The Forlinx module comes with two board-to-board connectors instead of solderable pads and can be found in the OK-MX9352-C single board computer with dual GbE, various display and camera interfaces, RS485 and CAN Bus, etc… FET-MX9352-C i.MX 9352 system-on-module Specifications: SoC – NXP i.MX 9352 with 2x Arm Cortex-A55 cores @ up to 1.7GHz (commercial) or 1.5 GHz (industrial), Cortex-M33 real-time core @ 250 MHz, 0.5 TOPS Arm Ethos U65 microNPU System Memory – 1GB/2GB LPDDR4 RAM Storage – 8GB eMMC flash 2x high-density 100-pin board-to-board […]

December 14, 2022 by Jean-Luc Aufranc (CNXSoft) - 7 Comments

Rockchip RK3588 system-on-module exposes 400 pins through high-density connectors

Rockchip RK3588 system -on-module with 400 pins

Forlinx FET3588-C is a relatively compact Rockchip RK3588 system-on-module measuring 68x50mm and exposing many of the processor’s I/Os through four 100-pin high-density connectors. The module ships with up to 8GB LPDDR4x and 64GB eMMC flash, and the company also provides the OK3588-C development board for evaluation with HDMI output and input, two MIPI DSI interfaces, five camera connectors, dual Gigabit Ethernet, M.2 sockets for WiFi and 4G/5G cellular connectivity, and more. Forlinx FET3588-C RK3588 system-on-module Specifications: SoC – Rockchip RK3588 octa-core processor with 4x Arm Cortex-A76 cores @ up to 2.4 GHz, 4x Arm Cortex-A55 cores, Arm Mali-G610 MP4 GPU with support for OpenGL ES3.2, OpenCL 2.2, Vulkan1.1, 6 TOPS NPU, 48MP ISP, 8Kp60 video decoding, 8Kp30 video encoding System Memory – 4GB or 8GB LPDDR4x (16GB planned) Storage – 32GB or 64GB eMMC 5.1 flash (128GB planned) Carrier board interface – 4x high-density 100-pin board-to-board connectors Storage – Up […]

December 13, 2022December 13, 2022 by Jean-Luc Aufranc (CNXSoft) - 1 Comment

Open AI Lab EAIDK-610 devkit targets computer vision education with OpenCV

Open AI Lab EAIDK-610 is an embedded AI development kit powered by a Rockchip RK3399 processor, recently added to Linux 6.1 and described as “popularly used by university students” in the kernel changelog. But I had never heard about it, and it turns out it’s because it’s popular with students in China, and most documentation is written in Chinese. The development board is equipped with 4GB LPDDR3, a 16GB eMMC flash, HDMI video output, Gigabit Ethernet and WiFi 5, a few USB ports, a 40-pin GPIO header, and more. EAIDK-610 specifications: SoC – Rockchip RK3399 System Memory – 4GB LPDDR3 Storage – 16GB eMMC flash and MicroSD card slot Video Output HDMI 2.0 up to 4Kp60 MIPI DSI up to 1280×720 @ 60 fps 4-lane eDP 1.3 Audio – Speaker header, built-in microphone, 3.5mm audio jack, I2S header, digital audio via HDMI Camera I/F – 2x MIPI CSI up to […]

December 11, 2022 by Jean-Luc Aufranc (CNXSoft) - 10 Comments

Alif Ensemble Cortex-A32 & Cortex-M55 chips feature Ethos-U55 AI accelerator

Alif Semiconductor’s Ensemble is a family of processors and microcontrollers based on Arm Cortex-A32 and/or Cortex-M55 cores, one or two Ethos-U55 AI accelerators, and plenty of I/Os and peripherals. Four versions are available as follows: Alif E1 single-core MCU with one Cortex-M55 core @ 160 MHz, one Ethos U55 microNPU with 128 MAC/c Alif E3 dual-core MCU with one Cortex-M55 core @ 400 MHz, one Cortex-M55 core @ 160 MHz, one Ethos U55 with 256 MAC/c, one Ethos U55 with 128MAC/c Alif E5 triple-core fusion processor with one Cortex-A32 cores @ 800 MHz, one Cortex-M55 core @ 400 MHz, one Cortex-M55 core @ 160 MHz, one Ethos U55 with 256 MAC/c, one Ethos U55 with 128MAC/c Alif E7 quad-core fusion processor with two Cortex-A32 cores @ 800 MHz, one Cortex-M55 core @ 400 MHz, one Cortex-M55 core @ 160 MHz, one Ethos U55 with 256 MAC/c, one Ethos U55 with […]