Linux News - Page 105 of 432 - CNX Software

November 2, 2021June 22, 2022 by Ian W MORRISON (Linuxium) - 19 Comments

Beelink U59 Review – Windows 11, Ubuntu on a Jasper Lake mini PC

Coupling a German submarine with a North American lake seems a perfect match in this topsy-turvy supply-constrained COVID-19 broken world we find ourselves in but that’s just what Beelink has figuratively done by launching their new Intel Jasper Lake mini PC, the U59. Beelink kindly sent one for review and I’ve looked at performance running both Windows 11 and Ubuntu 20.04. Beelink U59 Hardware Overview The Beelink U59 physically consists of a 124 x 113 x 42mm (4.88 x 4.45 x 1.65 inches) square plastic case. As an actively cooled mini PC, it uses Intel’s new 10 nm Jasper Lake N5095 processor which is a quad-core 4-thread 2.00 GHz Celeron processor boosting to 2.90 GHz with Intel’s UHD Graphics. The front panel has an illuminated power button, dual USB 3.1 ports, a Type-C USB 3.0 port with DisplayPort Alternate Mode, a 3.5mm headphone jack, and a reset pin-hole ‘CLR CMOS’. […]

November 2, 2021November 9, 2021 by Jean-Luc Aufranc (CNXSoft) - 8 Comments

Linux 5.15 LTS release – Main Changes, Arm, RISC-V and MIPS architectures

Linus Torvalds released Linux 5.15, an LTS version, this past Sunday: It’s been calm, and I have no excuse to add an extra rc, so here we are, with v5.15 pushed out, and the merge window starting tomorrow. Which is going to be a bit inconvenient for me, since I also have some conference travel coming up. But it’s only a couple of days and I’ll have my laptop with me. Sometimes the release timing works out, and sometimes it doesn’t.. Anyway, the last week of 5.15 was mainly networking and gpu fixes, with some random sprinkling of other things (a few btrfs reverts, some kvm updates, minor other fixes here and there – a few architecture fixes, couple of tracing, small driver fixes etc). Full shortlog appended. This release may have started out with some -Werror pain, but it calmed down fairly quickly and on the whole 5.15 was […]

November 1, 2021November 1, 2021 by Jean-Luc Aufranc (CNXSoft) - 27 Comments

Raspberry Pi Zero 2 W vs Radxa Zero – Features and benchmarks comparison

The just-announced Raspberry Pi Zero 2 W is not the first quad-core Arm SBC following Raspberry Pi Zero form factor, and back in 2017, the Banana Pi BPI-M2 Zero was introduced for $15, and the Radxa Zero was unveiled last June with an Amlogic S905Y2 SoC with price starting at $15 as well. With its Allwinner H2+ quad-core Cortex-A7 processor clocked at 1 GHz and a price bumped up to $23, the Banana Pi M2 Zero has mostly become irrelevant, but the Radxa Zero may still be considered by some people with a 1.8 GHz processor, and options for up to 4GB RAM, so let’s see how features compare against Raspberry Pi Zero 2 W, followed by some benchmark numbers. Raspberry Pi Zero 2 W vs Raxda Zero – Features If we just look at the comparison table, the Radxa Zero is equivalent or superior in almost every way, except […]

November 1, 2021November 3, 2021 by Jean-Luc Aufranc (CNXSoft) - 295 Comments

Giveaway Week – NanoPi R2S gateway

Here’s the 8th edition of CNX Software giveaway week! I’ll have seven items to give away to readers in the 2021 event with some help from two companies as I was short on available samples this year. We’ll start with NanoPi R2S gateway based on Rockchip RK3328 SoC, and equipped with 1 GB DDR4 RAM as well as two Gigabit Ethernet ports. I reviewed NanoPi R2S gateway at the end of last year with Armbian built Ubuntu 20.04 Focal, and it performed well under load thanks to the metal enclosure and optimized OS. The main downside is having a USB 2.0 port, especially if you intend to use it as external storage, but that’s the cost of having two Gigabit Ethernet ports on Rockchip RK3328 SoC, with one of those using the USB 3.0 interface. The giveaway includes the board and metal enclosure. It is already fully assembled. So you’ll […]

October 30, 2021December 23, 2021 by Jean-Luc Aufranc (CNXSoft) - 30 Comments

Build an open source-hardware Allwinner D1s RISC-V Linux SBC for under $10

We covered Allwinner D1s RISC-V processor with 64MB built-in RAM a few days ago, and we’ve just found out about Xassette-Asterisk, an open-source hardware board based on the processor that runs Linux (OpenWrt) and is said to cost less than $10 to make. This is significantly cheaper than the Allwinner D1 based Nezha RISC-V Linux SBC currently sold for a little over $100, a rather poor value. The cheaper board will not quite have the same applications with just 64 MB RAM and no HDMI, but it could be great for projects requiring a camera and/or a display, audio interfaces, plus some I/Os. Xassette-Asterisk specifications: SoC – Allwinner D1s single-core 64-bit RISC-V processor @ 1.008 GHz with 64MB DDR2 Storage – MicroSD card slot, 32 MBit SPI flash (W25Q32 – U2 on the board) Display I/F – 40-pin LCD connector, 6-pin touch panel interface, backlight power Camera I/F – 24-pin […]

October 29, 2021November 1, 2021 by Jean-Luc Aufranc (CNXSoft) - 2 Comments

Jetson SUB mini PC ships with Xavier NX SoM, 128GB SSD

Jetson SUB is a mini PC powered by NVIDIA Jetson Xavier NX module and equipped with a 512GB 128GB SSD, a WiFi module, all housed in an aluminum case with a cooling fan. [Update Nov 1, 2021: Seeed Studio informed me the SSD would only have 128 GB capacity] Preloaded with NVIDIA Jetpack, the mini PC is designed for higher-end edge AI and IoT workloads leveraging the 384 NVIDIA CUDA cores, 48 Tensor cores, the hexa-core Carmel 64-bit Arm processor, and the two NVIDIA Deep Learning Accelerators (NVDLA) engines from the Xavier NX SoC. Jetson SUB mini PC specifications: NVIDIA Jetson Xavier NX module CPU – 6-core NVIDIA Carmel ARMv8.2 64-bit processor with 6 MB L2 + 4 MB L3 cache GPU – NVIDIA Volta architecture with 384 NVIDIA CUDA cores and 48 Tensor cores Accelerators – 2x NVDLA Engines, 7-Way VLIW Vision Processor Video – Multiple 4Kp60 encode, multiple […]

October 29, 2021November 1, 2021 by Jean-Luc Aufranc (CNXSoft) - 19 Comments

Raspberry Pi Zero 2 W mini review – Benchmarks and thermal performance

The Raspberry Pi Foundation launched the Raspberry Pi Zero 2 W board yesterday with the main difference against Raspberry Pi Zero W board being the much faster Raspberry Pi RP3A0 SiP with a Broadcom quad-core Cortex-A53 processor clocked at 1.0 GHz and overclockable to 1.2 GHz. I received my sample shortly after publishing the announcement, and I had time to test it. Since the main difference is the processor, I’ll focus this review on benchmarks and whether additional cooling is required for the board. Raspberry Pi Zero 2 W kit unboxing If you purchase the board for $15, that’s all you’ll get, but Raspberry Pi Trading sent me a kit with Raspberry Pi Zero 2 W SBC, a USB OTG adapter, a mini HDMI to HDMI adapter, the CSI camera cable, and four rubber pad for the enclosure that comes with three covers: full, hole for 40-pin GPIO header, or […]

October 29, 2021 by Jean-Luc Aufranc (CNXSoft) - No Comments

SolidRun i.MX 8XLite SoM embeds DSRC modem, GPS for V2X automotive applications

The GPU-less NXP i.MX 8XLite Cortex-A35/M4 SoC was just announced earlier this month for V2X and IIoT applications, and now SolidRun unveiled the first module based on the new processor with the “i.MX 8XLite System-on-Module”. Also equipped with a RoadLINK SAF5400 safety modem, SolidRun’s Mini SoM targets vehicle telematics, vehicle-to-vehicle (V2V) and vehicle-to-infrastructure (V2I) communications, road infrastructure connectivity, and industrial equipment. SolidRun i.MX 8XLite specifications: SoC – NXP i.MX 8XLite single or dual-cire Cortex-A35 processor @ 1.2 GHz, with Cortex-M4F real-time core System Memory – 1GB LPDDR4 with inline ECC Storage – 8GB eMMC flash Ethernet – NXP TJA1100 100BASE-T1 Automotive Ethernet transceiver Wireless NXP RoadLink SAF5400 DSRC/802.11p (V2X) single modem dual antenna (u.FL connectors) GNSS module for GPS 2x Hirose DF40 board-to-board connectors with: Storage – SD/MMC card, PCIe SSD Ethernet – 100BASE-T1 Automotive Ethernet USB – 2x USB 2.0 PCIe – 1x PCIe Low-speed interfaces – 2x I2C, […]