mini pc News - Page 48 of 150 - CNX Software

October 22, 2021February 25, 2024 by Jean-Luc Aufranc (CNXSoft) - 3 Comments

BrainChip AKD1000 SNN AI SoC gets Raspberry Pi and x86 development kits

Brainchip Akida Raspberry Pi & Mini PC devkits

BrainChip has introduced two development kits for its Akida AKD1000 neuromorphic processor based on Raspberry Pi and an Intel (x86) mini PC in order to enable partners, large enterprises, and OEMs to begin testing and validation of the Akida chip. BrainChip Akida neural relies on spiking neural networks (SNN) which enable high-performance, real-time inference at ultra-low power, notably much lower power than traditional AI chips relying on CNN (convolutional neural network) technology. Akida Development Kit based on Raspberry Pi CM4 Specifications: SoM – Raspberry Pi CM4 or CM4 Lite with SoC: Broadcom BCM2711C0 quad-core ARM Cortex-A72 (ARMv8-A) 64-bit @ 1.5GHz plus Broadcom VideoCore VI GPU RAM – 1GB, 2GB, 4GB, or 8GB LPDDR4 SDRAM Storage – MicroSD card for CM4 Lite, or 2GB to 32GB eMMC for CM4 Networking – Optional 2.4 GHz and 5 GHz 802.11b/g/n/ac Wi-Fi, Bluetooth 5.0 LE, Gigabit Ethernet PHY Carrier board – Official Raspberry Pi […]

October 21, 2021October 21, 2021 by Ian W MORRISON (Linuxium) - 15 Comments

Beelink SER3 Review – A good AMD Ryzen 7 mini PC… after tweaks

Beelink has just launched a new mini PC called the SER3. It is another ‘new’ mini PC using an older CPU, in this case, an AMD mobile processor. However, the performance is surprisingly good once a few tweaks are made to the stock configuration. Beelink kindly sent one for review and I’ve looked at performance running both Windows and Ubuntu together with using an eGPU. Hardware Overview The SER3 physically consists of a 126 x 113 x 40mm (4.96 x 4.45 x 1.57 inches) square metal case. As an actively cooled mini PC, it uses AMD’s older 12 nm Zen+ Ryzen 7 3750H Picasso processor which is a quad-core 8-thread 2.3 GHz mobile processor boosting to 4.0 GHz with Radeon RX Vega 10 Graphics. The front panel has an illuminated power button, dual USB 3.0 ports, a Type-C USB 3.0 port with Alternate Mode, a 3.5mm headphone jack, and a […]

October 17, 2021 by Jean-Luc Aufranc (CNXSoft) - 3 Comments

Zidoo M6 preview with Android 11

I’ve now had more time to play with Zidoo M6 Arm mini PC powered by a Rockchip RK3566 quad-core Cortex-A55 processor. I intended to review the device with Ubuntu, but I misunderstood, and Android 11 was pre-installed on the device. I was also told since this model is mainly for industrial control, I might want to focus on performance and connectors rather than how well all functions work. So this will not be a review, but rather a preview of Zidoo M6, since as we’ll see below there’s still more work do to fix all issues. As an industrial platform. some features like Google Services may not be needed or even desirable. First boot and Settings I’ve connected a USB keyboard for screenshots, MINIX NEO A2 Lite air mouse, an HDMI cable to my 4K TV, and the power supply to get started. I also add two AAA batteries to […]

October 15, 2021October 21, 2021 by Jean-Luc Aufranc (CNXSoft) - 3 Comments

Rockchip RK3566 Benchmarks in Android 11 (Zidoo M6)

I received Zidoo M6 last month, a mini PC based on Rockchip RK3566 quad-core Cortex-A55 processor. I initially understood it came with Ubuntu Linux, but actually, it came pre-loaded with Android 11, so I’ve decided to run some benchmarks on the RK3566 device to see how it performs compared to other Arm systems Zidoo M6 system info But before running benchmarks, let’s have a look at some system info with CPU-Z CPU-Z has never heard about RK3566, so it detects it as RK3066, but the rest of the information seems correct with a quad-core Cortex-A55 clocked between 400 MHz and 1.8 GHz, an Arm Mali-G52 GPU, 3775KB RAM, and 24.12 GB internal storage from the 32GB flash. The system runs Android 11 on top of Linux 4.19 which will be supported until December 2024. I can set the video output to 4K, but the UI is still limited to 1920×1080 […]

October 15, 2021October 20, 2021 by Jean-Luc Aufranc (CNXSoft) - 30 Comments

ASUS PN41 mini PC offers 2.5GbE networking for $169 and up

When I looked for an SBC or a mini PC with 2.5GbE networking following the discontinuance of ODROID-H2+ SBC, I focused on systems with dual 2.5GbE ports to closely match Hardkernel’s SBC specifications, and most of those systems were rather expensive. But if a single 2.5 GbE port is enough for your application, then there’s a good alternative to ODROID-H2+ with ASUS PN41 mini PC powered by a choice of Jasper Lake processors, and pricing starting at $169 on Amazon for a barebone model with an Intel Celeron N4500 dual-core processor. ASUS PN41 mini PC specifications: Jasper Lake N-Series SoC (one or the other) Pentium Silver N6005 quad-core processor @ 2.0GHz / 3.3GHz (Turbo) with Intel UHD graphics; 10W TDP Celeron N5105 quad-core processor @ 2.0GHz / 2.9GHz with Intel UHD graphics; 10W TDP Celeron N4505 dual-core processor @ 2.0GHz / 2.9GHz with Intel UHD graphics; 10W TDP Pentium Silver […]

October 13, 2021October 13, 2021 by Jean-Luc Aufranc (CNXSoft) - 20 Comments

Beelink U59 Celeron N5095 Jasper Lake mini PC ships with up to 16GB RAM, 512GB SSD

Beelink U59 is a Jasper Lake mini PC based on an Intel Celeron N5095 15W quad-core processor that ships with 8GB RAM and a 256 GB M.2 SSD for $279+ on Amazon or Banggood, or $349+ with 16GB RAM and a 512 GB SSD. The mini PC offers two 4K HDMI 2.0 ports, a Gigabit Ethernet port, WiFi 5, as well as four USB 3.0 ports, and supports one 2.5-inch SATA drive up to 7mm thick. Beelink U59 specifications: SoC – Intel Celeron N5095 quad-core Jasper Lake processor @ 2.0GHz / 2.9GHz (Turbo) with 4MB cache, 16EU Intel UHD Graphics; 15W TDP System MEmory – 8GB or 16GB DDR4 2,933 MHz Storage – 256GB or 512GB M.2 SATA SSD with up to 500MB/s read speed. Support for 2.5-inch SATA drives (7mm thick max). Video Output – 2x HDMI 2.0 ports up to 4Kp60 Audio – 3.5mm audio (headphone & microphone) […]

October 4, 2021October 4, 2021 by Ian W MORRISON (Linuxium) - 5 Comments

MINIX NGC-5 Review – Windows 10, Ubuntu 20.04, and external GPU

MINIX has just launched a new mini PC in their NGC range called the NGC-5. Although it uses a somewhat dated Intel eighth-generation Core i5 processor, the integrated Iris Plus Graphics 655 is notable for being one of the more powerful iGPU solutions. MINIX kindly sent one for review and I’ve looked at performance running both Windows and Ubuntu together with using an eGPU. Hardware Overview The NGC-5 physically consists of a 153 x 153 x 43mm (6.02 x 6.02 x 1.57 inches) square plastic case. As an actively cooled mini PC, it uses Intel’s older 14 nm++ Core i5-8279U Coffee Lake processor which is a quad-core 8-thread 2.40 GHz processor boosting to 4.10 GHz with Intel’s Iris Plus Graphics 655. The front panel has just a LED power indicator whereas the rear panel includes dual gigabit Ethernet ports, dual USB 3.1 ports, a DisplayPort 1.2, an HDMI 2.0a port, […]

September 28, 2021September 28, 2021 by Jean-Luc Aufranc (CNXSoft) - 5 Comments

BMAX B1 PLUS Celeron N3350 Mini PC with 6GB RAM, 64GB eMMC flash sells for $105 (Promo)

We’ve been seeing some deep discounts for systems based on older Intel processors recently, and the $105 BMAX B1 Plus mini PC joins other systems such as a $100 Gemini Lake laptop or an Atom x5-Z8350 mini PC going for under $90 shipped. So what do you get for that price? An Intel Celeron N3350 dual-core Apollo Lake mini PC with 6GB RAM, 64GB eMMC flash, as well as an M.2 SSD slot, Gigabit Ethernet and WiFi 5, HDMI and VGA video output, and four USB ports. BMAX B1 PLUS specifications: SiC – Intel Celeron N3350 dual-core Apollo Lake processor @ 1.1 GHz / 2.4 GHz (Turbo) with Intel HD Graphics 500; 6W TDP System Memory – 6GB LPDDR4 Storage – 64GB eMMC flash, M.2 M-Key 2280 slot for SATA SSD, MicroSD card slot Video Output – HDMI 2.0 up to 4Kp60, VGA Audio – 3.5mm stereo audio jack, digital […]