ubuntu News - Page 66 of 167 - CNX Software

January 30, 2020 by Ian W MORRISON (Linuxium) - 4 Comments

Beelink Gemini T45 Pentium N4200 Mini PC Review

Beelink T45-Pentium N4200 Mini PC Review

No sooner had I written ‘Beelink T45 Review with Windows and Linux, and Tweaking BIOS Power Limits’ than Beelink announce they wouldn’t in fact sell that configuration but an ‘updated’ version. And it is significantly different because this new version is now actively cooled and uses an Apollo Lake N4200 processor. It also still has the same name: the Beelink Gemini T45. I’ve now reviewed this new version and you may experience déjà vu on reading the following as in keeping with Beelink’s philosophy I’ve basically reused the same text as before and just updated where appropriate. Beelink have further extended their ‘Gemini’ range of mini PCs by adding the T45. This is an actively cooled mini PC that uses the slightly older Apollo Lake Intel Pentium N4200 CPU which is a quad-core 4-thread 1.10 GHz processor boosting to 2.50 GHz with Intel’s HD Graphics 505. The T45 is a […]

January 17, 2020 by Jean-Luc Aufranc (CNXSoft) - 8 Comments

NVIDIA Jetson Nano Developer Kit-B01 Gets an Extra Camera Connector

Launched in March 2019, NVIDIA Jetson Nano developer kit offered an AI development platform for an affordable $99. The kit is comprised of Jetson Nano module and a carrier board, and the version I received last November ended with “A02”. Jetson Nano developer kit is now getting updated with B01 carrier board that adds an extra MIPI CSI connector and other few changes, including compatibility with NVIDIA Jetson Nano production module (with eMMC flash instead of MicroSD card). Jetson Nano developer kit-B01 specifications: B01 Jetson Nano CPU Module 128-core Maxwell GPU Quad-core Arm A57 processor @ 1.43 GHz System Memory – 4GB 64-bit LPDDR4 @ 25.6 GB/s Storage – microSD card slot Video Encode – 4K @ 30 | 4x 1080p @ 30 | 9x 720p @ 30 (H.264/H.265) Video Decode – 4K @ 60 | 2x 4K @ 30 | 8x 1080p @ 30 | 18x 720p @ 30 […]

January 16, 2020January 17, 2020 by Jean-Luc Aufranc (CNXSoft) - 34 Comments

NanoPi R2S Dual Gigabit Ethernet SBC & Router is Powered by Rockchip RK3328 SoC

FriendlyElec launched NanoPi R1S router with two Ethernet ports based on either Allwinner H3 or H5 processor coupled with 512MB RAM last November. Both ports are “Gigabit” Ethernet port, but one is implemented via a USB 2.0 to Ethernet controller with a maximum bandwidth of around 330 Mbps. If you’d like to get two Gigabit Ethernet reaching close to 1 Gbps each, and your target application would benefit from a bit more memory, the company is now working on NanoPi R2S based on Rockchip RK3328 processor with 1GB DDR4 memory, one Ethernet port using the GMAC from the chip, and one Ethernet port relying one a USB 3.0 to Ethernet controller. The rest of NanoPi R2S specifications are pretty similar to the earlier board except WiFi is also gone: SoC – Rockchip RK3328 quad-core Cortex-A53 @ 1.5 GHz with Arm Mali-450MP2 System Memory – 1GB DDR4 RAM Storage – MicroSD […]

January 13, 2020January 13, 2020 by Jean-Luc Aufranc (CNXSoft) - No Comments

Getting Started with Amlogic NPU on Khadas VIM3/VIM3L

Shenzhen Wesion released the NPU toolkit for Khadas VIM3/VIM3L last November, so I decided to try the latest Ubuntu 18.04 image and the NPU toolkit on Khadas VIM3L, before switching to VIM3 for reasons I’ll explain below. I’ve followed two tutorials from the forum and wiki to run pre-built samples and then building a firmware image and samples from source. Khadas VIM3L and VIM3 Have Different & Optional NPUs This will be obvious to anyone who read the specs for Khadas VIM3 and VIM3L that the former comes with a 5 TOPS NPU, while the one in the latter only delivers up to 1.2 TOPS. But somehow, I forgot about this, and assume both had the same NPU making VIM3L more attractive but this type of task, Obviously I was wrong. But the real reason I stopped using Khadas VIM3L can be seen in the photo below. My board is […]

January 3, 2020 by Ian W MORRISON (Linuxium) - 6 Comments

Beelink BT4 Mini PC Review – Slow, Buggy, Fan-cooled, and Overheating

Intel’s low-cost chip shortage has been so bad that Beelink has had to demothball some Atom chips when creating their new mini PC the Beelink BT4. This is one of the cheapest new mini PCs recently launched and uses the somewhat now old Cherry Trail Intel Atom x5-Z8500 CPU which was launched at the start of 2015 and is a quad-core 4-thread 1.44 GHz processor boosting to 2.24 GHz with Intel’s HD Graphics. The BT4 is the same form factor as the more recent Beelink mini PCs being a half-thick ‘NUC’ style device physically consisting of a 120 x 120 x 22 mm (4.72 x 4.72 x 0.87 inches) plastic rectangular case. This is not a passive device as it contains a small fan that stays on after the device has been shut down. The front panel has only a blue ‘power’ LED and the rear panel includes the power […]

December 31, 2019January 2, 2020 by Jean-Luc Aufranc (CNXSoft) - 2 Comments

OnLogic Introduces Four Apollo Lake Pico-ITX SBC’s with Integrated Heatsink

We previously covered some Apollo Lake Pico-ITX boards with the likes of GIGABYTE GA-PICO3350 or AAEON PICO-APL3 motherboards, but there are now more options with OnLogic – formerly known as Logic Supply – recently launching four Apollo Lake Pico-ITX SBC’s. OnLogic EPM160, EPM161, EPM162, and EPM163 are powered by either an Intel Celeron N3350 dual-core processor or an Intel Pentium N4200 quad-core SoC with different memory capacities, display and networking options. OnLogic EPM16x specifications: SoC EPM160, EPM161, EPM162 – Intel Celeron N3350 dual-core Apollo Lake processor @ 1.1 GHz / 2.4 GHz (Burst frequency) with Intel HD Graphics 500 EPM163 – Intel Pentium N4200 quad-core Apollo Lake processor @ 1.1 GHz / 2.5 GHz (Burst frequency) with Intel HD Graphics 500 System Memory / Storage EPM160 – 1 GB LPDDR4-2133, MicroSD card slot, mSATA (shared PCIe Mini Card slot) EPM161 – 2 GB LPDDR4-2133, 8GB eMMC flash, MicroSD card slot, […]

December 21, 2019February 29, 2020 by Ian W MORRISON (Linuxium) - 5 Comments

Beelink T45 Review with Windows and Linux, and Tweaking BIOS Power Limits

[Update December 23, 2019: We’ve been informed by Beelink that the T45 has been updated to the 6W Celeron N4200 processor instead, and the system is now cooled with a fan. The model reviewed in this post is the fanless version with a 10W Intel J4250 processor, which was never sold] [Update January 30, 2020: We’ve now posted a review of the new model at Beelink Gemini T45 Pentium N4200 Mini PC Review] Beelink have further extended their ‘Gemini’ range of mini PCs by adding the T45. This is a passively cooled mini PC that is effectively a companion to the J45 as it again uses the slightly older Apollo Lake Intel Pentium J4205 CPU which is a quad-core 4-thread 1.50 GHz processor boosting to 2.60 GHz with Intel’s HD Graphics 505. Although the T45 is a ‘NUC’ style mini PC physically consisting of a 119 x 119 x 17.7 […]

December 17, 2019December 18, 2019 by Jean-Luc Aufranc (CNXSoft) - 1 Comment

UP Xtreme Edge (UPX-Edge) Embedded Computer is Built around UP Xtreme Whiskey Lake SBC

AAEON UP Xtreme SBC was launched last June with a choice of 15W Whiskey Lake processors, namely Intel Celeron 4305UE dual-core processor, Intel Core i3-8145UE dual-core 4-thread processor, Intel Core i5-8365UE / Core i7-8665UE quad-core 8-thread processors. The company has now launched a complete embedded computer built around UP Xtreme SBC named UP Xtreme Edge Computing System, or simply UPX-Edge for short, that’s a slight variation of the fanless chassis offered for the SBC during the Kickstarter campaign. UPX-Edge specifications: SoC (one or the other) Intel Celeron 4305UE dual-core processor @ up to 2.2 GHz with 2MB cache, Intel UHD 610 graphics Intel Core i3-8145UE dual-core 4-thread processor @ up to 2.1 GHz / 3.9 GHz (Turbo) with 4MB cache, Intel UHD 620 graphics Intel Core i5-8365UE quad-core 8-thread processor @ up to 1.6 GHz / 4.1 GHz (Turbo) with 6MB cache, Intel UHD 620 graphics Intel Core i7-8665UE quad-core […]