Processors Category - Page 694 of 1078 - CNX Software

September 14, 2016July 31, 2020 by Jean-Luc Aufranc (CNXSoft) - 12 Comments

Widora-NEO OpenWrt WiFi IoT & Audio Board is Based on Mediatek MT7688 SoC, WM8960 Audio DAC

A couple of weeks ago, I reviewed ReSpeaker board combining MediaTek MT7688 WiFi SoC with WM8960 audio DAC, running OpenWrt, and allowing you to perform tasks using text-to-speech and speech-to-text thanks to the built-in microphone (or optional microphone array), and a 3.5mm audio jack to connect speakers, as well as several I/O pins. It turns out there’s been board with similar features, minus the built-in microphone, available in China for a while. Meet Widora-NEO. Widora-NEO board specifications: SoC – Mediatek MT7688AN MIPS SoC @ 580 MHz with built-in WiFi System Memory – 128 MB RAM Storage – 16MB SPI flash, micro SD card Connectivity – 10/100M Ethernet, 802.11 b/g/n WiFi 1T1R up to 150 Mbps with PCB antenna, or IPEX connector Audio – 3.5mm jack for stereo headphone and mono microphone, WM8960G audio codec USB – 1x micro USB port for programming via CP2104 chip, 1x micro USB host (or […]

September 14, 2016 by Jean-Luc Aufranc (CNXSoft) - 28 Comments

SCISHION V88 PRO TV Box Powered by Amlogic S905X SoC Sells for $22 (Promo)

Amlogic S905X was supposed to allow for cheaper TV boxes compared to Amlogic S905 ones thanks to more integration with built-in Ethernet and audio DAC, as well as support for 2-layer PCB. It also adds 4K VP9 support, but it’s mostly useful for YouTube 4K, a feature only available in devices running Android TV operating system, with Xiaomi Mi Box the only option that I’m aware of based on S905X. Amlogic S905X has also been found to be slower than Amlogic S905 processor, so unless you absolutely need Android 6.0 or/and VP9 support, there’s very little reason to buy an Amlogic S905X box if it’s more expensive, which was the case for most devices so far. SCISHION V88 PRO TV box changes that somewhat as the Amlogic S905X TV box is sold for just $21.99 on GearBest. SCISHION V88 Pro: SoC – Amlogic S905X quad core ARM Cortex A53 processor […]

September 13, 2016September 16, 2016 by Jean-Luc Aufranc (CNXSoft) - 9 Comments

$20 pcDuino4 Nano is Yet Another Allwinner H3 Development Board (Sort of)

We already have plenty of low cost Allwinner H3 development boards thanks to several Shenzhen Xunlong Orange Pi boards and FriendlyARM NanoPi boards among a few others. Here comes another one with pcDuino4 Nano. pcDuino4 Nano (preliminary?) specifications: SoC – Allwinner H3 quad core Cortex A7 @ 1.2 GHz with an ARM Mali-400MP2 GPU up to 600 MHz System Memory – 1GB DDR3 SDRAM Storage – micro SD card slot Video & Audio Output – HDMI and 3.5mm jack for CVBS (composite + stereo audio) Connectivity – 10/100M Ethernet USB – 3x USB 2.0 host ports, 1x micro USB OTG port Camera – DVP Interface Expansions – 40-pin Raspberry Pi compatible header with UART, SPI, I2C, PWM, GPIOs, etc… Debugging – 4-pin header for serial console Misc – Power and reset buttons; 2x LEDs; IR receiver; on-board microphone. Power Supply – 5V/2A via micro USB port; 5V via VDD_5V pin […]

September 12, 2016June 18, 2018 by Jean-Luc Aufranc (CNXSoft) - 11 Comments

Hisilicon Hi3798M V200 SoC to Allow for Cheaper 4K TV Boxes with Gigabit Ethernet, SATA, and/or USB 3.0

One year after Hisilicon Hi3798C V200 processor was unveiled at IBC 2015, Hisilicon has now introduced a cost down version named Hisilicon Hi3798M V200 at IBC 2016 with a lower-end Mali-450 GPU, only 2 TS input interfaces, one less USB 3.0 interface, and only 1x GMAC (Gigabit Ethernet MAC) or 1x Fast Ethernet PHY, instead of two GMAC interfaces. The processor also adds 1080p30 H.265 video encoding. Hisilicon Hi3798M V200 key features: CPU – Quad core Cortex A53 processor (15K DMIPS) GPU – ARM Mali-450 + Hisilicon dual-core GPU Memory I/F – 32-bit DDR3/3L/4 Storage I/F – eMMC/NAND/SPI, 1x SATA 3.0, 2x SDIO Video Engine (VPU) HiVXE 2.0 video engine supporting 4Kp60 10-bit H.265 and VP9 decoding, 4Kp30 H.264, MPEG-2, MPEG-4, VC1, VP6/VP8, Real Media 8/9/10 Encoder – H.264/H.265 @ 1080p30 or dual 720p30 Imprex 2.0 processing engine with support for HDR10 & HLG high dynamic range, BT.709/BT.2020, etc.. Peripherals: […]

September 12, 2016September 12, 2016 by Jean-Luc Aufranc (CNXSoft) - 12 Comments

Pine64 Unveils $2 PADI IoT Stamp WiFi IoT Module with FreeRTOS SDK, Upcoming ARM mbed 5.0 Support

Realtek RTL8710 WiFi IoT modules came out as potential competitors to ESP8266 modules last month, with similar features. an ARM Cortex M3, and a pricing as low as $2 in quantities. However, documentation is often in Chinese only, and based on my experience with an RTL8710AF module limited to AT commands set for now. Software and documentation are likely to improve a lot however, as Pine64, the makers of Pine A64 boards, are about to launch their own “PADI IoT Stamp” RTL8710AF module for just $1.99 in any quantities. PADI IoT Stamp specifications: SoC – Realtek RTL8710AF ARM Cortex-M3 @ 83 MHz with 1MB ROM, 512KB RAM, and 1MB flash Connectivity – 802.11 b/g/n WiFi @ 2.4 GHz – 2.5 GHz (2400 MHz – 2483.5 MHz) with PCB antenna; Station / SoftAP / SoftAP + Station modes; Expansion headers – 22 half-holes with Up to 1x SPI @ 41.5 Mbps […]

September 12, 2016 by Jean-Luc Aufranc (CNXSoft) - No Comments

Explore M3 Board based on NXP LPC1768 Cortex M3 MCU Comes with Lots of Tutorials (Crowdfunding)

Explore M3 is an ARM Cortex M3 development board powered by a micro USB port, with plenty of I/Os, Arduino compatible, and the developers have also written many tutorials to help people getting started as fast and easily as possible. A starter kit with cables and sensors is also available with the board. Specifications: MCU – NXP LPC1768 ARM Cortex M3 @ up to 100MHz with 512KB flash, 64KB RAM, USB – 1x micro USB 2.0 OTG port for programming and power Expansion Headers – 2x 20-pin male headers + 8-pin unpopulated header with 38x GPIOs, 4x UARTs, 2x CAN, 2x SPI, 2x I2C, 6x PWM, 5x ADC, 1x DAC, 2x interrupt pins, I2S audio, and power signal Debugging – JTAG/SWD Debug connector Misc – USB boot and reset buttons Dimensions – 55mm x 25mm The hardware is somewhat similar to mbed LPC1768 board but with a few more I/Os. […]

September 11, 2016November 14, 2017 by Jean-Luc Aufranc (CNXSoft) - 11 Comments

Vernee Apollo Lite Helio X20 Smartphone Review – Part 2: Android 6.0 Firmware

I’ve already taken pictures and shown Antutu benchmark in the first part of Vernee Apollo Lite review, an Android 6.0 smartphone powered by Mediatek Helio X20 deca-core processor. Now that I’ve had time to play with the phone for over 10 days, I’ve ready to report my experience and write the second part of the review about performance, features, and issues I encountered with the phone. General Impressions First, the build quality feel pretty good, the phone is light and slim. I’ve only called once or twice, and voice quality was good, but I mostly use my phone over WiFi to browse the web, check emails, watch YouTube, and access social networks. More rarely, I also use GPS while running and during trip, and play some games. To be honest, the first few days did not work as expected, as many apps would either be much slower than last year […]

September 9, 2016October 24, 2016 by Jean-Luc Aufranc (CNXSoft) - 30 Comments

Beelink GT1 4K TV Box Review – Part 1: Unboxing and Teardown

Beelink GT1 is among the cheapest Amlogic S912 TV boxes available today, selling for around $56, but despite the inexpensive price tag, its specifications are not too bad with Gigabit Ethernet, 802.11ac WiFi, 2GB RAM, 16GB flash, and 4K H.265 & VP9 video capabilities. The company sent me a sample for review, and as usual, I’ll start by posting photos, and having a look at the hardware design, before reviewing the firmware in more details in a the second part of the review. Beelink GT1 Unboxing My package appears to have had a rough trip, but apart from the edges of the black retail package nothing was damaged. The main specifications are shown on the bottom of the package together with CE and FCC certifications, and the type of power adapter inside the package. GT1 ships with a simple IR remote control, a shortish HDMI cable (~1 meter), a small […]