ESP8266 based ANAVI Light Controller can be Programmed with Home Assistant or the Arduino IDE (Crowdfunding)

ANAVI Technology previously launched a Light pHAT allowing for RGB Light strip connection to Raspberry Pi boards, and during my review of ANAVI Light pHAT with Raspberry Pi 2, it did the job, but if that’s all you want to do, the  Raspberry Pi board is clearly oversized & overpowered for the job.

So Leon ANAVI got back to the drawing board and designed a similar open source hardware board – called ANAVI Light Controller – with an built-in ESP8266 module that removes the need for a fully fledged Linux board.

ANAVI ESP8266 Light Controller ANAVI Light Controller specifications:

  • Wireless Module – ESP8266MOD module based on ESP8266 Tensilica L106 32-bit processor
  • Connectivity – WiFi 802.11 b/g/n
  • Expansion
    • Terminal block for 12 V RGB LED strip
    • 3x I2C headers for sensors
  • Debugging – UART header
  • Misc – Button
  • Power Supply – 12 V via power barrel jack
  • Dimensions – 75 mm x 40 mm
  • Certification – Open Source Hardware Association (OSHWA) BG000005

ESP8266 RGB LED Strip

The board can be programmed with the Arduino IDE or Home Assistant, and controlled with MQTT or any modern web browser. Since the project is open source hardware, all KiCad & OpenSCAD hardware design files and open source firmware can be found on AnaviTechnology Github account.

Supported I2C modules include BH1750 light sensor, HTU21D temperature and humidity sensor, and APDS-9960 RGB color and gesture detection sensor. A one meter 12 V RGB LED strip with 30 LEDs is provided in the kits.

The project has just launched on CrowdSupply with a symbolic $1 funding target.  If you just need the board, a pledge of $25 will do, but for a complete kit (minus power supply), you’d need to pledge at least $39 for a starter kit with an LED strip, acrylic case and a USB to serial debug cable.  The $59 Developer kit will be more fun to use as it also adds all 3 sensor modules listed above.  Shipping is free worldwide, and delivery is planned for end of August to end of September depending on rewards.

Share this:
FacebookTwitterHacker NewsSlashdotRedditLinkedInPinterestFlipboardMeWeLineEmailShare

Support CNX Software! Donate via cryptocurrencies or become a Patron on Patreon

ROCK Pi 4C Plus

Leave a Reply

Your email address will not be published. Required fields are marked *

Weller PCB manufacturer
Weller PCB manufacturer