Qualcomm Atheros Category - Page 9 of 12 - CNX Software

February 14, 2017February 14, 2017 by Jean-Luc Aufranc (CNXSoft) - 10 Comments

Dragino OLG01 Outdoor Single Channel LoRa Gateway Runs OpenWrt, Supports Passive PoE

Dragino Technology, a Shenzhen based startup focusing on the Internet of Things, had already designed LoRa shields & Hats for Arduino & Raspberry Pi boards which can be useful for LoRa nodes, but the company has now launched Dragino OLG01 LoRa gateway running OpenWrt that communicates with nodes over LoRa, and to the cloud using WiFi, Ethernet, or 3G/4G. Dragino OLG01 specifications: WiSoC – Atheros AR9331 MIPS processor @ 400MHz System Memory – 64MB RAM Storage – 16MB flash MCU – Atmel ATMega328P AVR MCU with 32KB flash, 2KB SRAM Connectivity 802.11 b/g/n WiFi with antenna 2x 10/100M Ethernet with support for passive PoE Optional 3G/4G module connected to internal USB socket (TBC) Semtech SX1276/78 LoRa wireless module + SMA connector (antenna not provided) up to 5~10 km range USB – 1x USB 2.0 host port Power Supply – 12V DC power jack or PoE Three models are offered with […]

January 13, 2017January 14, 2017 by Jean-Luc Aufranc (CNXSoft) - 8 Comments

Xiaomi Mi R3P AC2600 Wireless Router is up for Pre-order for $127 without Hard Drive

Xiaomi introduced Mi Router HD, an AC2600 router with 1 or 8 TB HDD storage, at CES 2017. The exact same router now appears to be up for pre-order on GearBest for $127, but without any hard drive, which should allow you to use to own. GearBest does not call it “Mi Router HD” but instead “Xiaomi Mi R3P”. The photos match the ones of the product unveiled at CES 2017, and the preliminary specifications can be derived from various sources: SoC – Qualcomm IPQ8064 quad core network processor System Memory – TBD Storage – Flash storage for firmware (TBD); SATA drive support Connectivity 802.11 a/b/g/n/ac WiFi up to 2600 Mbps with 4 antennas 3x Gigabit Ethernet LAN ports, 1x Gigabit Ethernet WAN port USB – 1x USB 3.0 port Dimensions – 19 x 13 x 6.5 cm Weight – 1.030 kg Just like other Xiaomi routers it can be […]

January 6, 2017January 6, 2017 by Jean-Luc Aufranc (CNXSoft) - 8 Comments

Xiaomi Router HD AC2600 WiFi Router Comes with up to 8TB Storage

Xiaomi has unveiled a new WiFi router at CES 2017. Mi Router HD is an AC2600 WiFi router that’s also use as a personal NAS with a “surveillance-class” hard drive with up to 8TB capacity. Mi Router HD key features: SoC – Qualcomm IPQ8064 quad core network processor with a dual-core Qualcomm Krait CPU @ 1.4 GHz for control plane and applications, and a dual-core 730 MHz Network Subsystem (NSS) to accelerate packet processing. 4×4 multi-user 802.11ac MIMO router, supports up to 2600 Mbps transfer speeds 4 high-gain PCB array antennas Built-in surveillance-class hard drive of up to 8TB Automatically back up all your devices, supports Time Machine Automatically syncs with Dropbox Integrates with Sonos audio system The router will launch this trimester in China with either 1TB hard drive for under $200, or an 8TB hard drive for under $500. It will very likely be sold through Aliexpress, GearBest, […]

November 10, 2016 by Jean-Luc Aufranc (CNXSoft) - 3 Comments

8Devices Rambutan Qualcomm Atheros QCA9557 / QCA9550 GbE & WiFi Modules and Development Kit Run OpenWrt

8Devices, a Lithuanian company specialized in the development and manufacturing of electronic equipment, is known for their Carambola and Carambola2 WiFi modules powered by Ralink and Qualcomm Atheros WiSoCs. The company has now introduced a new dual band WiFi module called Rambutan that comes in commercial and industrial temperature range through respectively Qualcomm Atheros QCA9557 & QCA9550 SoCs. Rambutan and Rambutan-I modules specifications: SoC Rambutan – Qualcomm Atheros QCA9557 MIPS processor @ 720 MHz Rambutan-I – Qualcomm Atheros QCA9550 MIPS processor @ 720 MHz System Memory – 128 MB DDR2 Storage – 128 MB Flash Connectivity WiFi – 802.11 a/b/g/n, 2.4 or 5 GHz, 2×2 MIMO, 300 Mbps data rate, 21 dB per chain output power; 2x u.FL connectors Ethernet – Atheros AR8032 10/100M Ethernet PHY 68x half holes with 2 x USB 2.0 host port 2 x serial port 1x 100 Base-T Ethernet port; 1000 Base-T Ethernet port (SGMII […]

July 26, 2016July 27, 2016 by Jean-Luc Aufranc (CNXSoft) - 6 Comments

Music802 Linux Audio & IoT Board is Powered by Atheros AR9331 SoC (Crowdfunding)

When Link Card evaluated processors for a Linux audio IoT board, they considered candidates like Allwinner H3 and Ralink RT5350, but eventually went with Atheros AR9331 due to cost, simplicity, features, and power consumption reasons for their Music802 board based on LC930 system-on-module. Music802 board specifications: SoC – Atheros AR9331 MIPS 24K WiSoC @ 400 MHz System Memory – 64MB DDR2 Storage – 16MB SPI Flash Audio – Cirrus Logic WM8960 Codec; 2x 3.5 mm jacks for Line IN and headphone; optical S/PDIF output; on-board microphone Connectivity – 2x 10/100M Ethernet ports (WAN & LAN), 802.11 b/g/n WiFi with 1x IPEX antenna connector USB – 1x USB 2.0 host, 1x micro USB port for power only Debugging – 3-pin 2.54mm pitch header for serial console Expansion – 16-pin 2.0mm pitch header for GPIO, UART, I2C, etc.. Misc – Power, system, and 2x user LEDs, 1x reset button, 1x power switch […]

July 25, 2016May 29, 2017 by Jean-Luc Aufranc (CNXSoft) - 7 Comments

Linux 4.7 Release – Main Changes, ARM and MIPS Architectures

Linux 4.7 is out: So, after a slight delay due to my travels, I’m back, and 4.7 is out. Despite it being two weeks since rc7, the final patch wasn’t all that big, and much of it is trivial one- and few-liners. There’s a couple of network drivers that got a bit more loving. Appended is the shortlog since rc7 for people who care: it’s fairly spread out, with networking and some intel Kabylake GPU fixes being the most noticeable ones. But there’s random small noise spread all over. And obviously, this means that the merge window for 4.8 is open.Judging by the linux-next contents, that’s going to be a bigger release than the current one (4.7 really was fairly calm, I blame at least partly summer in the northern hemisphere). Linus Linux 4.6 brought USB 3.1 superspeed, OrangeFS distributed file system, 802.1AE MAC-level encryption (MACsec), and BATMAN V protocol support, improved […]

July 5, 2016 by Jean-Luc Aufranc (CNXSoft) - 1 Comment

Wi-Fi CERTIFIED ac Wave 2 Products Support MU-MIMO, 160 MHz Channels, and More

802.11ac WiFi is now found in many routers and devices, and the Wi-Fi alliance has so far certified close to 3,000 “Wi-Fi CERTIFIED ac” products. I understand that certification is not mandatory, but if you want to make sure a device works well, the certification at least means the devices have been tested for interoperability, security and application specific protocols, and found to work in a satisfactory manner. Now the Wi-Fi alliance has announced Wi-Fi CERTIFIED ac Wave 2 certification program with the following new requirements: MU-MIMO (Multi-user Multiple Input Multiple Output) in order to send data to multiple devices at once to improve overall network efficiency and throughput 160 MHz channels support (not only 80 MHz) potentially doubling transmission speeds Four spatial streams instead of just three spatial streams. Extended 5 GHz channel support by adding more channels in the 5 GHz to reduce interference and congestion. Currently the […]

May 13, 2016 by Jean-Luc Aufranc (CNXSoft) - No Comments

Arduino Industrial 101 Board Powered by Atmel AVR and Atheros AR9331 WiSoC Targets Industrial IoT Applications

Arduino boards were first used by hobbyists, educators and their students, but in recent year more and more professional engineers have started to build prototypes with Arduino boards before moving to the design of the final product. Arduino Srl went further by designing an industrial grade board, namely Arduino Industrial 101, combining an Atmel AVR for real-time I/O control, and a Qualcomm Atheros AR9331 for WiFi connectivity. Arduino Industrial 101 (A000126) specifications: Arduino part MCU – Atmel ATmega32u4 AVR MCU @ 16 MHz with 32KB flash, 2.5 KB SRAM, 1KB EEPROM Digital I/O Pin – 20, with 7 PWM and UART Analog Input Pins – 12 DC Current per I/0 – 40 mA Operating Voltage – 5V Linux (LininoOS) part (101 Industrial LGA “Chiwawa” module) Processor – Atheros AR9331 MIPS processor @ 400 MHz System Memory – 64 MB DDR2 Storege – 16 MB flash WiFi – 802.11 b/g/n […]